Phenolic is a hard, dense material made by applying heat and pressure to layers of paper or fabric, impregnated with a synthetic resin. These phenolics are approx half the weight of aluminum and their physical toughness resists abrasion, friction, impact, and material fatigue. Special properties fight off the corrosive action of water and many chemicals, increasing the service life and efficiency of your product parts. The insulating qualities of each grade, such as low dissipation factor and excellent dielectric strength, make them valuable for many precise electrical and electronic applications. The strength-to-weight ratio of these phenolics make them ideally suited for countless product parts. They are high in tensile, compressive, flexural, and impact strength and possess good working characteristics. They machine quickly and easily. Grade G-10 is a light green, continuous filament woven glass fabric grade, impregnated with epoxy resin. Has excellent electrical values, possesses low moisture absorption, low dissipation factor, excellent electrical characteristics over a wide range of humidities and temperatures. It will withstand up to 284°F. Moisture absorption rate .15%. Electrical Applications Coils/Coil Supports, End Laminations, Fuse Cases, High Voltage, Television, Insulation, Insulating Structural Members, Primary and Secondary Barrier Insulation, Relay Insulation, Slot Cell Insulation, Spool Heads, Standoff Insulators, Stator/Generator Insulation, Switchboard Panels, Switches, Tap Changers, Terminal Boards, Top Sticks. Non-Electrical Applications Backing Plates, Bearings, Bobbins, Bushings, End Posts, Gaskets, Gears, Grommets, Guides, Oil Seal Rings, Piston Washers/ Rings, Post Formed Backing Discs, Pulleys, Rotor vanes, Rubbing Blocks, Slides, Slip Rings, Sound Insulators, Structural Members, Thrust Washers, Valve Discs/Seats, Washers, Wear Plates.

GENERIC PROPERTY SHEET

GENERIC PROPERTY SHEET